This article needs additional citations for verification. (November 2024) |
The Bethungra Spiral is a heritage-listed rail spiral on the Main Southern line near Bethungra, between Junee and Cootamundra. The spiral carries the northbound track, forming a part of the Sydney–Melbourne rail corridor.[1][2]
| Bethungra Spiral | |
|---|---|
 Tracks diverging at southern end of the spiral; looping track of the spiral on hillside in the middle distance | |
| Location | Main Southern railway, Bethungra, Junee Shire, New South Wales, Australia |
| Coordinates | 34°44′59″S 147°52′53″E / 34.7498°S 147.8813°E |
| Built | 1946 |
| Owner | Transport Asset Holding Entity |
| Official name | Bethungra Spiral |
| Type | state heritage (complex / group) |
| Designated | 2 April 1999 |
| Reference no. | 1026 |
| Type | Other - Transport - Rail |
| Category | Transport - Rail |
  Location of Bethungra Spiral in New South Wales | |
It is a listed heritage item, having been added to the New South Wales State Heritage Register on 2 April 1999.[3]
History
editThe original single-track line, opened in 1878, was graded at 1 in 40 for Sydney bound trains, which imposed a severe limitation on train loads and also caused congestion as bank engines were attached and detached.[4]
When the line was duplicated in the late 1940s, an 8.9 kilometre spiral deviation was built. The spiral makes use of local geography in the shape of a convenient hill around which the uphill ("up", or Sydney-bound) track spirals in order to gain the necessary height over a longer distance, thus giving a lesser gradient. However, the fact that the hill is on the "down" (southbound) side of the original track necessitated two crossings of the original line by the new northbound track — one a tunnel to take it to the eastern (or "down") side of the original track in order to then spiral around the hill, and a viaduct beyond the spiral to take the new track back to the left hand side of the original line, as Australian trains run on the left, as in the UK, France and Japan. The Spiral has two short tunnels, one already mentioned at the beginning of the Spiral, for the "up" track to cross beneath the original line to reach the "down" side, and a second tunnel that allows it to pass over itself at a later point in the Spiral, having circled the hill to gain height.
The spiral increased the distance travelled by uphill (northbound) trains by about two kilometres. Downhill (southbound) trains continue to use the original line. The ruling gradient of the new uphill line is 1 in 66.[4][5][6]
Due to the extensive blasting required to create 27-metre deep cuts through granite, the line suffers from rockfalls, with twelve significant falls happening between 1960 and 1987. In January 1994, the spiral line closed for a four-month rebuild, which saw the cuts widened and regraded to benched 55 degree slopes as part of the One Nation project.[4][7]
Description
edit
Starting at the lower left corner of the interactive map, the "up" track to Cootamundra (and thence to Sydney) is the one on the left. It diverges from the "down" track and has been built at a less steep gradient than the "down" track and so is able to pass under it (through a tunnel) then sweeping around the hill (passing through the second tunnel in the process), gaining elevation all the while until crossing over itself above the second tunnel. It is now higher than the down track and on its right (if northbound), and at an overpass further north (click on "Full screen" to view), crosses back over to the left and eventually the two tracks converge just short of the Olympic Highway level crossing.
Heritage listing
editThe Bethungra Spiral is of high significance, illustrating a means of ascending a significant mountain range with easier grades than the original line (now the "down" track). It is a major civil work and an ingenious engineering solution using the technology available at the time of construction. The site has major landscape value.[3]
Bethungra Spiral was listed on the New South Wales State Heritage Register on 2 April 1999 having satisfied the following criteria:
The place possesses uncommon, rare or endangered aspects of the cultural or natural history of New South Wales.
This item is assessed as historically rare. This item is assessed as scientifically rare. This item is assessed as architecturally rare.[3]
Tourism
edit
A traveller who has just passed through Bethungra township on the way to Cootamundra is alerted to its existence nearby by a sign indicating the turnoff to the Rail Spiral Lookout and Bethungra Dam on the right of the Olympic Highway. An all-vehicle dirt road leads, after about 3 km, to a parking area and interpretive signboard. Nearby is the substantial viewing platform from where may be seen the Sydney-bound train emerge from the tunnel and two minutes later cross over that same tunnel.
There are other spots on that road from where three railway tracks can be seen at three different heights on the adjacent hillside to the east of the Olympic Highway. The bottom and top tracks are the "up" (northbound) track before and after it has crossed the "down" (southbound) track and traversed the Spiral, while the middle track is the original single-track line, which is now the "down" (southbound) track.
Inland Rail
editThe route of the proposed Inland Rail entails a new section of line from Illabo, west of Bethungra, to Stockinbingal, to obviate the need for northbound trains on the Inland Railway to climb the Bethungra Spiral to Cootamundra then drop down to Stockinbingal to continue north towards Forbes then Parkes. It is projected that this section of the Inland Railway will be completed by 2025. The Spiral will remain in use as part of the Melbourne-Sydney line.[8]
Model railway
edit
The Epping Model Railway Club, of Epping, New South Wales, has created a detailed model of the spiral in HO scale. The setup, which measures approximately 5 by 3 metres (16 ft × 10 ft) is demountable and is occasionally shown as a fully operational exhibit at appropriate functions.[9]
2022 derailment
editAround 0340 on 15 January 2022 ten trucks of a 1,500 metres (4,900 ft) freight train left the rails at the highest point of the spiral, above the cutting. Fortunately the affected carriages did not fall into the cutting, and no injuries were recorded but the line was out of action for a week while the damaged carriages were being removed and the track repaired.[10]
References
edit- ^ Bethungra Spiral NSWrail.net
- ^ Bethungra - Frampton SA Track & Signal
- ^ a b c "Bethungra Spiral". New South Wales State Heritage Register. Department of Planning & Environment. H01026. Retrieved 2 June 2018.
Text is licensed by State of New South Wales (Department of Planning and Environment) under CC BY 4.0 licence.
- ^ a b c "The Bethungra Spiral Rectification Project" Railway Digest June 1994 pages 12-15
- ^ "Doubling, Deviation & New Construction Works" Railway Gazette 18 July 1941 page 54
- ^ "Main-Line Deviation in Australia" Railway Gazette 14 January 1949 pages 42-45
- ^ "Bethungra Spiral". Railway Digest. May 2014. p. 39.
- ^ "Illabo to Stockinbingal (NSW)". Inland Rail. Australian Rail Track Corporation. Retrieved 10 May 2019.
- ^ "Model Train Show: Bethungra Spiral". ARTC Inland Rail. 22 March 2022. Retrieved 27 June 2022.
- ^ James Cameron (24 January 2022). "Investigation ongoing into mysterious freight train derailment at Bethungra Spiral". about region. Retrieved 13 August 2023.
Attribution
edit
This Wikipedia article was originally based on Bethungra Spiral, entry number 1026 in the New South Wales State Heritage Register published by the State of New South Wales (Department of Planning and Environment) 2019 under CC-BY 4.0 licence, accessed on 5 March 2019.
External links
edit
Media related to Bethungra Spiral at Wikimedia Commons
- "Bethungra Spiral (listing NSW5011929)". Australia Heritage Places Inventory. Department of Sustainability, Environment, Water, Population and Communities. Retrieved 13 August 2008.
- Trip Advisor