File:Sea-level variations from Sentinel-3A ESA359994.jpg

Original file (1,173 × 870 pixels, file size: 996 KB, MIME type: image/jpeg)

Summary

Description
English: Presented this week at ESA’s Living Planet Symposium in the Czech Republic, this new map shows a month of ‘sea-level anomaly’ measurements from Sentinel-3A. The satellite has only been in orbit since 16 February 2016 and is therefore still being commissioned for service. Nevertheless, measurements made by its radar altimeter between 3 March and 2 April have been used to create this map, which shows differences in sea-surface height compared to the mean.

Sea-level anomaly is the most basic altimeter data product. Red (positive) areas show where the sea surface is higher than the reference sea level and blue (negative) areas show where it is lower. Positive anomalies are associated with warmer waters and a deeper ‘thermocline’ and negative anomalies are associated with cooler waters and a shallower ‘thermocline’ – the transition layer between warmer mixed water at the ocean's surface and cooler deep water below. The plot at the base of the sea-level anomaly map shows the normalised distribution of data, indicating a global mean of 7 cm and a standard deviation of 11 cm. Using local sea-level variations measured by Sentinel-3’s altimeter and comparing them to a reference level, major ocean currents can be computed and mapped. Mesoscale eddy systems are clearly shown on the map as more intense blue and red patterns – effectively local hills and valleys in the sea surface. These are associated with the strong western boundary currents of the Gulf Stream in the North Atlantic, the Brazil current confluence with the Falklands current in the southeast Atlantic, the Benguela current off South Africa and the Kurishio current east of Japan. Strong positive variability is also seen in the equatorial Pacific Ocean associated with oceanic tropical instability waves generated by instabilities within the equatorial currents themselves.  The Sentinel-3A radar altimeter will also measure significant wave height and provide estimates of surface wind speeds over the ocean, which is important information for ocean and wave forecasting systems operated by the Copernicus Marine Environmental Monitoring Service. 

The radar altimeter data in this map were processed using France’s CNES space agency’s processing prototype (S3PP), with ESA level-0 data as input. A wet tropospheric correction was derived from European Centre for Medium-Range Weather Forecasts’ models.
Date
Source http://www.esa.int/spaceinimages/Images/2016/05/Sea-level_variations_from_Sentinel-3A
Author European Space Agency
Permission
(Reusing this file)
contains modified Copernicus Sentinel data (2016), processed by ESA and CNES,CC BY-SA 3.0 IGO
Other versions
Title
InfoField
Sea-level variations from Sentinel-3A
Set
InfoField
Living Planet Symposium 2016
Mission
InfoField
Sentinel-3
Activity
InfoField
Observing the Earth

Licensing

w:en:Creative Commons
attribution share alike
This file is licensed under the Creative Commons Attribution-ShareAlike 3.0 IGO license.
You are free:
  • to share – to copy, distribute and transmit the work
  • to remix – to adapt the work
Under the following conditions:
  • attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.
  • share alike – If you remix, transform, or build upon the material, you must distribute your contributions under the same or compatible license as the original.
© This image contains data from a satellite in the Copernicus Programme, such as Sentinel-1, Sentinel-2 or Sentinel-3. Attribution is required when using this image.
Attribution: Contains modified Copernicus Sentinel data {{{year}}}

The use of Copernicus Sentinel Data is regulated under EU law (Commission Delegated Regulation (EU) No 1159/2013 and Regulation (EU) No 377/2014). Relevant excerpts:


Financial conditions

Free access shall be given to GMES dedicated data [...] made available through GMES dissemination platforms [...].

Conditions regarding use

Access to GMES dedicated data [...] shall be given for the purpose of the following use in so far as it is lawful:

  1. reproduction;
  2. distribution;
  3. communication to the public;
  4. adaptation, modification and combination with other data and information;
  5. any combination of points (a) to (d).

GMES dedicated data [...] may be used worldwide without limitations in time.

Conditions regarding information to be given by users
  1. When distributing or communicating GMES dedicated data [...] to the public, users shall inform the public of the source of that data and information.
  2. Users shall make sure not to convey the impression to the public that the user’s activities are officially endorsed by the Union.
  3. Where that data or information has been adapted or modified, the user shall clearly state this.
Absence of warranty

GMES dedicated data and GMES service information are provided to users without any express or implied warranty, including as regards quality and suitability for any purpose.

Captions

Add a one-line explanation of what this file represents

Items portrayed in this file

depicts

10 May 2016

File history

Click on a date/time to view the file as it appeared at that time.

Date/TimeThumbnailDimensionsUserComment
current13:27, 7 May 2017Thumbnail for version as of 13:27, 7 May 20171,173 × 870 (996 KB)European Space Agency, Id 359994, http://www.esa.int/spaceinimages/Images/2016/05/Sea-level_variations_from_Sentinel-3A, User:Fæ/Project_list/ESA

The following page uses this file:

Global file usage

The following other wikis use this file:

Metadata