Kwa-di Tabil-class ferry

(Redirected from Kwa-di Tabil class ferry)

Kwa-di Tabil-class ferries[2] (kwah-DEE-tah-BALE) were built for Washington State Ferries to replace the retired Steel Electric-class ferries. The vessels serve lower-traffic routes and carry up to 64 vehicles. The State of Washington spent approximately $213 million to construct the three ferries in this class.[3]

Kwa-di Tabil class
MV Chetzemoka, the first of the class, sailing into Keystone Harbor (2011)
Class overview
BuildersTodd Pacific Shipyards, Seattle, Washington
OperatorsWashington State Ferries
Preceded bySteel Electric class
Built2009–2012
In service2010–present
Planned3
Completed3
Active3
General characteristics
TypeAuto/passenger ferry
Tonnage4,623
Displacement1,515 long tons of displacement
Length273 ft 8 in (83.41 m)
Beam64 ft (20 m)
Draft11 ft (3.4 m)
Decks7
Deck clearance16 ft 1 in (4.9 m) max
Installed power6,000 hp (4,500 kW) total from two EMD 710 diesel engines
Speed15 knots (28 km/h; 17 mph) max
Capacity
  • 748 passengers
  • 64 vehicles (maximum)
Crew10[1]

In the design stage, the class was called the 100 Vehicle-class[4] and later 64 Vehicle-class ferries.[5][6]

Ferries

edit

Ferries in this class include:

History

edit

In November 2007, Washington State Ferries made the decision to remove the 80-year-old Steel Electric-class ferries from service over safety concerns. Routine inspections revealed serious hull corrosion damage on two of the four old vessels. When the Steel Electrics were removed from service, there were no ferries able to carry vehicles on Port Townsend-Coupeville route as no other vessel could be used in Coupeville's small, shallow Keystone Harbor.[7]

Due to the vessel shortage created by the sudden retirement of the Steel Electric-class ferries, Washington State Ferries (WSF) decided to base the design of the Kwa-di Tabil-class ferries on an existing ferry, Island Home, which runs between Martha's Vineyard, Massachusetts and Woods Hole, Massachusetts. The Washington State Legislature authorized and funded vessel construction in February 2008[8] and the first vessel was built on tight 18-month schedule by Todd Pacific Shipyards in Seattle (by state law all new WSF vessels are built in Washington).[8]

The first ferry, Chetzemoka, was christened by Governor Christine Gregoire and began service November 14, 2010[9] on the Port Townsend-Coupeville route. Two boat service returned to the route on July 1, 2011 with the delivery of the second ferry, Salish.[10] Kennewick entered service on February 14, 2012 and was assigned to the Port Townsend-Coupeville route, allowing Chetzemoka to be reassigned to the Point Defiance–Tahlequah route and the 65-year-old ferry Rhododendron to be retired.

Issues

edit

The Kwa-di Tabil-class ferries have had a number of problems since they were delivered. Most seriously, the non-symmetrical design of the ships caused them to list noticeably to one side. After a few months in service, ballast was added to one side of the vessels to correct the list.[11][12]

Despite promises that the Kwa-di Tabil-class ferries were designed to serve all routes and terminals in the WSF system, they have proven to be ill-suited for many routes.[11] The narrow car decks on the ferries make it difficult to turn vehicles around[11] (necessary on the inter-island route in the San Juan Islands and on the Fauntleroy / Vashon / Southworth route). During a December 2012 and January 2013 fleet emergency, Salish was pressed into service on the well-traveled Bremerton-Seattle run. It was at that time that it was discovered that the diesel fuel-hungry engines on the Kwa-di Tabil-class ferries struggled to make the 15.5 knots (28.7 km/h; 17.8 mph) speed for which they had been designed, and Salish averaged at best 13 knots (24 km/h; 15 mph).[13]

References

edit
  1. ^ "Getting on and off Chetzemoka: Learning how to use state's newest ferry". Port Townsend Leader. Retrieved 2021-12-20.
  2. ^ Chew, Jeff. "Kwa-di Tabil: Students to be feted today for naming class of new state ferry". Peninsula Daily News. Archived from the original on 2012-03-24. Retrieved 2011-07-01.
  3. ^ "New ferry Kennewick joining Washington fleet". The Seattle Times. January 6, 2012. Retrieved 30 April 2012.
  4. ^ "Vessel Planning Study" (PDF). Wsdot.wa.gov. 2008. Retrieved 27 July 2019.
  5. ^ "Island Home Design" (PDF). Leg.wa.gov. Retrieved 27 July 2019.
  6. ^ Wolff, Douglas (November 16, 2007). "Tradition and Innovation: The Design of the Ferry Island Home" (PDF). Elliott Bay Design Group. Archived from the original (PDF) on 2011-10-09. Retrieved 2011-07-27.
  7. ^ "News & Media | Governor Jay Inslee". Governor.wa.gov. Archived from the original on March 12, 2008.
  8. ^ a b "SB 6794" (PDF). Apps.leg.wa.gov. Retrieved 27 July 2019.
  9. ^ Gilmore, Susan (14 November 2010). "Washington state's newest ferry, Chetzemoka, christened Sunday". The Seattle Times.
  10. ^ "New state ferry Salish enters service". Komonews.com. Retrieved 27 July 2019.
  11. ^ a b c "The Kwa-di Tabil Class". Evergreenfleet.com. Retrieved 2015-04-16.
  12. ^ Elliott, Walt (2013-06-06). "A look at the issues regarding newest ferries". Kitsap Daily News. Retrieved 2021-12-20.
  13. ^ "The Salish". Evergreenfleet.com. Retrieved 2015-04-16.
edit