The darwin (d) is a unit of evolutionary change, defined by J. B. S. Haldane in 1949.[1] One darwin is defined to be an e-fold (about 2.718) change in a trait over one million years. Haldane named the unit after Charles Darwin.
Equation
editThe equation for calculating evolutionary change in darwins ( ) is:
where and are the initial and final values of the trait and is the change in time in millions of years. An alternative form of this equation is:
Since the difference between two natural logarithms is a dimensionless ratio, the trait may be measured in any unit. Inexplicably, Haldane defined the millidarwin as 10−9 darwins, despite the fact that the prefix milli- usually denotes a factor of one thousandth (10−3).[2]
Application
editThe measure is most useful in palaeontology, where macroevolutionary changes in the dimensions of fossils can be compared. Where this is used it is an indirect measure as it relies on phenotypic rather than genotypic data. Several data points are required to overcome natural variation within a population. The darwin only measures the evolution of a particular trait rather than a lineage; different traits may evolve at different rates within a lineage. The evolution of traits can however be used to infer as a proxy the evolution of lineages.
See also
edit
References
edit- ^ J.B.S. Haldane (1949). "Suggestions as to quantitative measurement of rates of evolution." Evolution 3:51–56.
- ^ Gingerich, Philip D. (2019). Rates of Evolution: A Quantitative Synthesis. Cambridge: Cambridge University Press (CUP). p. 13. ISBN 978-1-107-16724-7. OCLC 1057781904.