New South Wales AD60 class locomotive

The New South Wales AD60 class were Beyer-Garratt patent articulated four-cylinder, simple, non-condensing, coal-fired superheated, 4-8-4+4-8-4 heavy goods steam locomotives built by Beyer, Peacock & Company for the New South Wales Government Railways in Australia.

New South Wales AD60 class
6012 at the top of Cowan Bank
Type and origin
Power typeSteam
BuilderBeyer, Peacock & Company
Manchester
Serial number7473–7497, 7528–7549
Build date1952–1954, 1956
Total produced42
Specifications
Configuration:
 • Whyte4-8-4+4-8-4
Gauge1,435 mm (4 ft 8+12 in) standard gauge
Driver dia.4 ft 7 in (1,397 mm)
Length108 ft 7 in (33.096 m)
Adhesive weight282,000 lb (128,000 kg)
later 317,000 lb (144,000 kg)
Loco weight562,000 lb (255,000 kg)
later 582,000 lb (264,000 kg)
Fuel typeCoal
Fuel capacity14 long tons
(14.2 tonnes; 15.7 short tons)
later
18 long tons
(18.3 tonnes; 20.2 short tons)
Firebox:
 • Grate area65 sq ft (6.0 m2)
Boiler pressure200 psi (1.38 MPa)
Heating surface3,030 sq ft (281 m2)
Superheater:
 • Heating area750 sq ft (70 m2)
Cylinders4
Cylinder size19.25 in × 26 in
(489 mm × 660 mm)
later
19.875 in × 26 in
(505 mm × 660 mm)
Valve gearWalschaerts
Performance figures
Tractive effort59,560 lbf (264.9 kN)
later 63,490 lbf (282.4 kN)
Factor of adh.4.73 or 4.99
Career
OperatorsNew South Wales Government Railways
ClassAD60
Number in class42
Numbers6001–6042
First runJuly 1952
Last runMarch 1973
Preserved6029, 6039, 6040, 6042
Disposition4 preserved, 38 scrapped

Design

edit

The AD60 Class 4-8-4+4-8-4 Beyer-Garratt patent consists of a boiler carried on a separate frame in the centre of the locomotive and supported by the frames of the two engines, one at each end. The locomotive thus consists of three parts: a front engine unit carrying a water tank, an intermediate chassis pivoted to each engine unit supporting a boiler and cab, and a rear engine unit carrying a coal bunker and water tank. The standard gauge coupled axle loading of 16 long tons (16.3 t; 17.9 short tons) and able to negotiate 6-chain (120 m; 400 ft) curves.

The design incorporated the most modern technology to minimise maintenance and repairs, including:

Introduction

edit

This was the only type of Garratt locomotive to operate on the New South Wales Government Railways. Designed to a light axle load of only 16 long tons (16.3 t; 17.9 short tons), they were intended for hauling feeder branch-line services to the main lines where heavier main-line locomotives could continue with the load.[1][2][3]

In 1949, twenty-five were ordered from Beyer, Peacock & Company, followed by a further twenty-five.[4][5] Following a change of policy in favour of diesel traction, negotiations were entered into, in order to cancel the last part of the order. Forty-two complete locomotives were delivered, together with spare parts equating to approximately five further locomotives.[6] The five sets of parts did not include engine unit frames. The cancellation contract stipulated that the NSWGR could not assemble the spare parts into complete locomotives without paying substantial royalties to Beyer-Peacock. The last three locomotives were cancelled completely and the assembly positions at the Gorton Works of Beyer-Peacock were sold to the South African Railways.

The locomotives were delivered in their five major component pieces: Front engine, rear engine, boiler-cab, rear bunker and front water tank. These five sub assemblies were built into a complete locomotive in NSW.

Locomotive 6002 was the first to enter service in July 1952 with the last, 6040 delivered on 2 January 1957.[1][3][7] The locomotives were the most powerful to operate in Australia but behind the D57 in terms of tractive effort.[8]

Improvements

edit

Early trials established that the 14-long-ton (14.2 t; 15.7-short-ton) bunker was insufficient to allow the locomotives to operate from Enfield to Goulburn resulting in the bunkers being enlarged to carry 18 long tons (18 t; 20 short tons). Ventilation of the cabs caused considerable concern. Consequently, the class was banned from working through single-line tunnels, this ban also being in response to the difficulty crews would have climbing out in the event of failure within such tunnels. Amongst attempts to improve cab ventilation, 6011 was experimentally fitted in September 1952 with a large tube along the front bunker and boiler to funnel air from the front of the locomotive into the cab. It was unsuccessful and was removed in 1955. Some improvement was obtained by running the locomotives bunker first.[3]

Owing to the length and noise of the locomotive, crews found difficulty in hearing warning detonators. To rectify the situation, tubes were fitted to convey the sound from the leading wheels to the cab. This mechanism can still be seen today on 6040 at the NSW Rail Museum.[3]

When it became apparent that the Garratts would see more service on main lines than on the lighter branch lines, it was decided to increase the tractive effort of a number of the class by enlarging the cylinder diameter and by altering the weight distribution by removing liners from the bogies. This increased the axleload on each of the driving wheels by approximately 2 long tons (2.0 t; 2.2 short tons) with 30 locomotives treated. To distinguish these improvements the double plus sign ++ was painted after the number and they were nicknamed Super Garratts.[9] These 30 were also fitted with dual controls for bunker first running and denoted DC. To accommodate them, 105-foot (32 m) turntables were installed at Broadmeadow, Enfield and Werris Creek depots.[3]

Operation

edit

The class initially entered service on the Main North and Main South and later Main Western line as far as Dubbo and Parkes. Because of their light axle load they were cleared to operate on the Crookwell, Captains Flat, Temora, Narrandera and Bourke lines.[1]

Typical workings in the mid 1960s would consist of bulk export coal and general goods movements :

Typical class AD60 traffic
Route Traffic Down
(tons)
Up
(tons)
Notes
Glenlee to Rozelle Yard Export coal 1,500
Gosford to Broadmeadow Export coal 1,500 double-headed AD60s
Gosford to Broadmeadow General freight 685 (single) 1,100 (assisted)
Broadmeadow to Muswellbrook General freight 775 1,150
Newstan/Awaba Colliery to Wangi Power Station Export coal 1,075 1,500 assisted
Enfield to Goulburn General freight 900 1,500
From Botany Oil Refineries Petroleum 1,000
Goulburn to Captains Flat Mineral 600 600
Junee Goods 600 600
Cootamundra to Stockinbingal Goods 1,000 1,500
Up to Lithgow assisting until electrification in 1957
Parkes to Goobang Junction Goods 1,000 1,400 16-ton axle load locos only
Dubbo to Merrygoen Goods 1,100 1,000 16-ton axle load locos only
Parkes to Bogan Gate/Tottenham Goods 1,000 1,400 16-ton axle load locos only
Portland to Pipers Flat Cement 700
Pipers Flat to Wallerawang Cement 1,400
Dubbo to Werris Creek Goods 1,100
Lithgow to Bathurst Goods 850 900
Orange to Parkes Goods 600
Bathurst westward Goods 850 900 dependent on grade
W44 Broken Hill Concentrates 575 600 double-headed AD60s
Molong to Orange Goods 600 600 double-headed AD60s

Demise and preservation

edit

6012 was the first of the class to be withdrawn in February 1956. It was rumoured that the loco had been dropped while being unloaded.[10] The next few to be withdrawn suffered accident damage in major collisions in 1961 (6003 Geurie) and 1963 (6028 Glenlee - rebuilt and returned to service by 1965).

In September 1968, the highest numbered member of the class, 6042, was to be shopped at Cardiff Locomotive Workshops for overhaul. At the same time, 6010 already made up from a mix of original parts including the boiler cradle from 6043, the front water tank of 6039 and the coal bunker of 6021 was nearing completion in the same works. As pressure was increasing upon the works staff to expedite steam locomotive overhauls, the decision was taken to switch numbers between the two, which gave the impression that 6042 had received an overhaul in one day. Photographs were taken of the two locomotives together. The real 6042 (identified as 6021) was towed away scrapped.[11]

Dieselisation accounted for the gradual withdrawal of the other 39 of the class from 1965. The last withdrawn was the replacement 6042, which operated the final New South Wales Government Railways steam service on 22 February 1973. Shortly after, it was chosen to work the ceremonial Last Steam Train from Newcastle to Broadmeadow on 2 March 1973, where it was ceremonially driven through a celebratory banner by Transport Minister Milton Morris.

Number Year Owner Location Status Ref
6029 1954 Transport Heritage NSW Thirlmere Operational [12]
6039 1956 Dorrigo Steam Railway & Museum Dorrigo Displayed but not open to the public
6040 1957 Transport Heritage NSW Thirlmere Static exhibit [13]
6042 1956 Dorrigo Steam Railway & Museum Forbes Derelict [14][15]

References

edit
  1. ^ a b c Oberg, Leon (1984). Locomotives of Australia 1850's - 1980's. Frenchs Forest: Reed Books. pp. 204–206. ISBN 0-730100-05-7.
  2. ^ Oberg, Leon (2007), Locomotives of Australia, 1854 to 2007 (4th ed.), Rosenberg Publishing, pp. 261–263, ISBN 978-1-877058-54-7
  3. ^ a b c d e Grunbach, Alex (1989). A Compendium of New South Wales Steam Locomotives. Sydney: Australian Railway Historical Society. pp. 241–247. ISBN 0-909650-27-6.
  4. ^ Notes and News Railway Gazette 15 November 1949 page 630
  5. ^ The AD-60 Class Garratt Locomotives Australian Railway Historical Society Bulletin issue 178 August 1952 page 97
  6. ^ Compromise Agreement on Locomotive Contract Railway Transportation February 1955 page 12
  7. ^ 255 ton British built Locomotives for New South Wales Locomotive, Railway Carriage & Wagon Review issue 721 September 1952 pages 137-139
  8. ^ Sectioned Beyer Garratt locomotive model 6001 Powerhouse Museum
  9. ^ AD60 Class Beyer Garratt Locomotives of the New South Wales Railways Locomotives International isue 24 June 1994 pages 12-20
  10. ^ Groves, K., Wright, H., & Morahan, M., (1994). The 60 Class, New South Wales Rail Transport Museum
  11. ^ Preston, R.G., (1995) A Tale of Two Garratts, "Essays in Steam"', Eveleigh Press, Sydney
  12. ^ UK built Garratt recruited to museum fleet in bargain buy Heritage Railway issue 294 10 June 2022 page 28
  13. ^ NSW Locomotive, Steam 6040 Office of Environment & Heritage
  14. ^ Forbes Vintage Village Auction Railway Digest January 1987 page 27
  15. ^ Landlocked giant left to rust in peace Track & Signal issue 23/4 November 2019 pages 86/87
edit

  Media related to New South Wales AD60 class locomotives at Wikimedia Commons