The Rover 16/50 and Rover 16 are mid-sized cars which were produced by Rover from 1926 to 1929 and non-continuously from 1936 to 1947 respectively.

Rover initially responding to requests for a more powerful engine for their four-cylinder 14 hp with the 16/50. It remained available into 1929 finishing its run soon after the demise of its smaller bore 14 hp twin. Meanwhile, Rover had begun to provide a six-cylinder 16 hp offering, their 2-litre, in its turn succeeded by their 16 hp Meteor.

Production of a considerably revised replacement for Rover's 16 hp Meteor was resumed under the name Rover 16 in mid 1936 and, with a gap for World War II, the 16 remained in Rover's catalogue until it was replaced by the Rover 75 in early 1948.

Rover 16/50

edit
Rover 16/50
Overview
ManufacturerRover[1]
Production1926–1929[1]
Body and chassis
Body style
  • 2-door open 2 or 3 seater
  • 4-door open five-seater
  • 2-door coupé
  • 4-door Weymann saloon
  • 4-door coachbuilt saloon
  • 2-door or 4-door open sports
  • chassis only[2][3]
LayoutFR[2]
Powertrain
Engine2,413 cc (147.3 cu in) Straight-4[2]
Dimensions
Wheelbase
  • 120 in (3,048 mm)
  • Track 54 in (1,372 mm)[1]
Length178 in (4,521 mm)[1]
Width72 in (1,829 mm)[1]
Kerb weightSaloon 24 cwt, 2,688 lb (1,219 kg)[1]
Chronology
PredecessorRover 14/45
SuccessorRover Two-litre
Rover 16/50
Overview
ManufacturerRover
Layout
ConfigurationStraight 4-cylinder overhead camshaft[2]
Displacement2,413 cc (147.3 cu in)[2]
Cylinder bore80 mm (3.15 in)[2]
Piston stroke120 mm (4.72 in)[2]
Valvetrainoverhead camshaft[2]
Combustion
Fuel typepetrol[2]
Cooling systemwater[1]
Output
Power output
  • 50 bhp (37 kW; 51 PS) @ unreported rpm
  • Tax horsepower 15.87[1]

Announced 21 May 1926 to supplement their 14/45 the 16/50 engine had a larger bore and was now rated at 16 rather than 14 hp for tax purposes. Its cubic capacity was 2.4-litres instead of 2.1-litres. The whole chassis closely follows the design of the 14/45 as does the design of the new engine.[2] The 75 mm bore of the 14/45 has been increased by 5 mm.[4]

Engine

edit

The new engine has a Lanchester vibration damper on the front end of its crankshaft. Its camshaft and valves are overhead, the valves being set at an angle of 45 degrees on either side of the spark plug. At the back of the engine there is a vertical shaft to drive the camshaft. The camshaft works the inlet valves through rockers and by horizontal pushrods works the exhaust valves on the opposite side. The whole mechanism is enclosed and the covers are easy to remove. The double springs on the valve stems have variable tension. Though removing the cylinder head is not as simple as on a conventional design its removal does not affect the timing of the engine or its magneto. The crankshaft has three bearings, the camshaft four. The air supply to the carburettor is routed through a tunnel in the crankcase and in this way the air is slightly warmed while cooling the crankshaft's central bearing. The pistons are manganese with tubular connecting rods and the gudgeon pins receive positive oiling.[4]

Water coolant is fed through a honeycomb radiator by a water impeller in unit with the belt-driven fan drawing air through the radiator.[4]

Pressure feeds from the one reservoir provide automatic oiling to: engine, clutch, spigot-bearing, gearbox and steering, The central bearing in the torque tube is fed from the back axle.[4]

Petrol is kept in a tank midway in the frame and fed to an Autovac on the dash. The dynamo is driven from the gearbox by an enclosed silent type chain.[4]

Chassis

edit

Steering is by worm and wheel. The steering box is fixed to the cylinder head and a long drop arm provides good leverage. The clutch uses a single plate and runs in oil. The 4-speed gearbox is a strengthened version of the 14/45 gearbox. It is assembled as a unit with the engine. It is operated by a right-hand change speed lever with reach adjustable for the driver. Gearbox lubrication is from the engine and automatic. Final drive is by spiral bevel[2][4]

Brakes on all four wheels are operated by the foot pedal, those in front use the Perrott system. Pressure is distributed evenly by rods operated from a central location. The circular section front axle supports the chassis through underhung half-elliptical springs. The semi-elliptical back springs have central anchorages which can swivel about the axle case.[4]

Body

edit

The saloon's windscreen is V-shaped. The side windows have two sliding panels, two winding panels and fixed panels at the rear of the six-light body. The Weymann saloon's front seat is slidable by hand. The spare wheel is carried at the back of the body in front of the folding luggage grid.[4]

Retrospective

"It was a car with doors that closed with the convincing clunk of a railway carriage, interiors trimmed with wood and leather, and an instrument panel with clear clock-faces. It had furnishings that looked like those in a doctor’s sitting room or even a consulting room, door cappings with fine inlays, and door pockets with leather flaps like giant tobacco pouches. The Doctor’s Coupé was a car for strong men in tweed plus-fours who preferred things built to last."Eric Dymock, Rover: The First Ninety Years 1904-1994.[5]

Road test

edit

The Times' reviewer thought the engine's hemispherical combustion chambers and angled overhead valves unnecessarily complex. Four wheel brakes were provided and the overall braking system was, the reviewer thought, the best part of the whole car. Seating was comfortable in both front and back of the four-door saloon tested and the doorways The Times graded as "usable". There was just adequate headroom. The suspension rocked the saloon fore and aft if there were just two passengers. Comfortable maximum speed would be 55 to 60 mph.[4]

The reviewer also commented that the price seems high for a four-cylinder 16 hp car. The open car was priced at £575, the Weymann saloon £675 and the coachbuilt saloon £775.[4]

Rover 16 P2 (1937–1948)

edit
Rover 16
 
6-light saloon registered October 1947
Overview
ManufacturerRover
Production1937–1940
1945–1948
Body and chassis
Body style
  • four-door 6-light saloon[6]
  • four-door 4-light sports saloon"[6]
  • two-door drop head coupé[6]
Powertrain
Engine2147 cc straight 6
Dimensions
Wheelbase113 in (2,870 mm)[1]
Length175 in (4,445 mm)
Width62.5 in (1,588 mm)
Chronology
PredecessorRover Meteor 16
SuccessorRover 75

The Rover 16 was a medium-sized family car announced in mid-August 1936[7] and produced by the British Rover car company between 1936 and 1940 as a successor to the Rover Meteor 16. It was put back into production in 1945 following the Second World War and remained on sale until replaced by the Rover P3 in 1948. The 16 was part of the Rover P2 range, along with Rover 10, Rover 12, Rover 14 and Rover 20 models.[8]

The car, with its mildly streamlined form, resembled the existing Rover 10 and the Rover 12 but was slightly longer and featured a more rounded back end. The six-cylinder ohv engine had a capacity of 2,147 cc. A top speed of 124 km/h (77 mph) was claimed. In addition to a “six-light” saloon and a “four-light” "sports saloon, a two-door cabriolet was available, usually referred to as a drophead coupé, with bodywork by Tickfords.

The sports saloon and the drophead coupé had slightly less length between the front and rear seats, but a longer bonnet, with the front footwell extending further beneath the bonnet.

A version called the Rover 14 saloon combined the same body with (from 1938) a 1,901 cc six-cylinder engine. There was also a version called the Rover 20 with a 2512 cc. engine.

Notable features included a "freewheel" system, Bijur-Luvax automatic lubrication of the chassis, and Girling rod actuated fully compensated mechanical brakes of exceptionally high efficiency.

Road test

edit

Said the correspondent of The Times, "The Rover Sixteen is exceptionally attractive by reason of its quiet gentle manner, sweet running, comfort and spruceness in and out." Further lengthy comment was lyrical. The sole concern was that the engine could with advantage be rather more powerful. Comfortable maximum speed — 75 mph.[9]

The Rover 16 saloon returned to production almost unchanged after the war, but with a different inlet manifold, and the horizontal SU carburettor was replaced with a Zenith downdraught unit, and the white metal crankshaft main bearings were replaced with shell bearings. The drop head coupe version was no longer listed.

 
1947 sports saloon
 
 
1947 6-light saloon
 
1947 sports saloon interior
 
 
 
1939 drophead coupé
 

References

edit
  1. ^ a b c d e f g h i Culshaw; Horrobin (1974). Complete Catalogue of British Cars. London: Macmillan. ISBN 0-333-16689-2.
  2. ^ a b c d e f g h i j k New Model Rover Motor-Car. The Times, Saturday, May 22, 1926; pg. 9; Issue 44278
  3. ^ R Hough and M Frostick, Rover Memories, George Allen & Unwin, London, 1966
  4. ^ a b c d e f g h i j Cars Of To-Day. The Times, Tuesday, Dec 28, 1926; pg. 6; Issue 44464
  5. ^ Eric Dymock, Rover: The First Ninety Years. One of Britain's Fine Cars 1904-1994, London, G T Foulis & Co, 1993 ISBN 0951875019
  6. ^ a b c Rover Company Ltd. The Times, Tuesday, Aug 15, 1939; pg. 11; Issue 48384
  7. ^ Cars Of 1937. The Times, Wednesday, Aug 19, 1936; pg. 8; Issue 47457
  8. ^ Rover production total – since 1904 (as of 1 July 2004), rovercarclubaust.asn.au Retrieved 2 June 2015
  9. ^ Cars of Today, The Times, Friday, Mar 18, 1938; pg. 6; Issue 47946.
edit