Talk:Crowbar (circuit)

Physics Low‑importance

	Physics portal This article is within the scope of WikiProject Physics, a collaborative effort to improve the coverage of Physics on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.PhysicsWikipedia:WikiProject PhysicsTemplate:WikiProject Physicsphysics articles
Low	This article has been rated as Low-importance on the project's importance scale.

Electronics Low‑importance

	Electronics portal This article is part of WikiProject Electronics, an attempt to provide a standard approach to writing articles about electronics on Wikipedia. If you would like to participate, you can choose to edit the article attached to this page, or visit the project page, where you can join the project and see a list of open tasks. Leave messages at the project talk pageElectronicsWikipedia:WikiProject ElectronicsTemplate:WikiProject Electronicselectronic articles
Low	This article has been rated as Low-importance on the project's importance scale.

Systems Low‑importance

	Systems science portal This article is within the scope of WikiProject Systems, which collaborates on articles related to systems and systems science.SystemsWikipedia:WikiProject SystemsTemplate:WikiProject SystemsSystems articles
Low	This article has been rated as Low-importance on the project's importance scale.
	This article is within the field of Control theory.

Circuit needs a description

Latest comment: 1 year ago3 comments3 people in discussion

This article includes a single unidentified circuit diagram, but the article text describes several types of crowbar circuits. Which specific type of circuit is shown in the diagram? DMahalko (talk) 15:38, 25 January 2011 (UTC)Reply

The fuse in the circut will blow if the triac is triggered. I don't completely understand the trigger, but i'm guessing it occurs when the supply voltage exceeds a limit determined by the ratio R1/R2. Power flows from left to right: The power supply (not shown) connects to the left-hand side of the diagram, and the protected device (also not shown) is connected on the right. Once the crowbar is tripped, the only way to reset it is to replace the fuse. 206.210.75.84 (talk) 21:53, 6 March 2013 (UTC)Reply

The TL431's trigger level is 2,5 V. Henrik Haftmann (talk) 14:59, 7 December 2022 (UTC)Reply

Extra but undocumented functionality

Latest comment: 1 year ago1 comment1 person in discussion

This circuit using a Triac rather than an SCR has an additional protection against reversed polarity. However, residual reverse voltage is higher than using Si diodes or Schottky diodes. In case of reverse voltage, the TL431 will conduct with its output protection diode. This current will eventually fire the triac. --Henrik Haftmann (talk) 14:54, 7 December 2022 (UTC)Reply

Add topic