Talk:Data circuit-terminating equipment

	This article is within the scope of WikiProject Computing, a collaborative effort to improve the coverage of computers, computing, and information technology on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.ComputingWikipedia:WikiProject ComputingTemplate:WikiProject ComputingComputing articles
Low	This article has been rated as Low-importance on the project's importance scale.
	This article is supported by Networking task force (assessed as Mid-importance).
	This article is supported by Computer hardware task force (assessed as Mid-importance).

Telecommunications High‑importance

	Telecommunication portal This article is within the scope of WikiProject Telecommunications, a collaborative effort to improve the coverage of Telecommunications on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.TelecommunicationsWikipedia:WikiProject TelecommunicationsTemplate:WikiProject TelecommunicationsTelecommunications articles
High	This article has been rated as High-importance on the project's importance scale.

Highest clock rate

Latest comment: 11 years ago1 comment1 person in discussion

What is the highest clock rate possible to use on the DCE? What determines what clock rate should be used? What is the difference between the clock rates?

What is the highest clock rate possible to use on the DCE?

That has more to do with the design of the DCE itself and the protocol being used for the interface between the DTE and DCE. For example, if the protocol is RS232C, it's typical not to exceed 500000 bps.

What determines what clock rate should be used?

prior arrangement between DTE and DCE. That's why serial terminals and computer serial port with terminal emulator software have a data rate selection/setting, so that the speed can be adjusted based on to what DCE it's connected.

What is the difference between the clock rates?

You'll have to be more specific with your question. As-is, a direct answer by way of example would be, the difference between a 38.4KHz clock and a 9.6KHz clock (two rates typically used on RS232C) is 28.8KHz. (by which time, you'd probably say "duh...") -- Joe (talk) 19:37, 8 February 2013 (UTC)Reply

Add topic