 | This article is rated Stub-class on Wikipedia's content assessment scale. It is of interest to the following WikiProjects: | ||||||||||
| |||||||||||
.jpg){kind=small}
Is this a "noise resistance" that is "equivalent", or is it a "resistance" corresponding to an "equivalent noise"? If the latter, I think it should be hyphenated, thus: equivalent-noise resistance; since that way it's unambiguous. Michael Hardy 23:11, 14 Mar 2005 (UTC)
- Agreed. — Omegatron 15:54, 17 August 2006 (UTC)
- None of the above. Noise may be measured in units of resistance, i.e. ohms. If you've got e.g. a single-transistor pre-amp hooked to an antenna, this is a handy figure for figuring out how much noise is going to come out of that transistor. linas 04:34, 4 December 2006 (UTC)
- The hyphenated version would be noise-equivalent resistance. (FWIW, my credentials? I once did some GPS signal processing. For an omni antenna, the GPS signal is 20 dB under the noise. I learned the hard way you can't amplify your way out of that.) linas 16:47, 4 December 2006 (UTC)