Talk:Extruder (3D printing)

This article is within the scope of WikiProject Technology, a collaborative effort to improve the coverage of technology on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.TechnologyWikipedia:WikiProject TechnologyTemplate:WikiProject TechnologyTechnology articles

Engineering Low‑importance

	Engineering portal This article is within the scope of WikiProject Engineering, a collaborative effort to improve the coverage of engineering on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.EngineeringWikipedia:WikiProject EngineeringTemplate:WikiProject EngineeringEngineering articles
Low	This article has been rated as Low-importance on the project's importance scale.

On 11 May 2021, it was proposed that this article be moved from Bowden extruder to 3D printer extruder. The result of the discussion was moved.

Unnamed section

In the disadvantages it states that Bowden extruders push rather than pull the filament. Although this is true, this is also true for all extruders, including direct drive. The only difference is the length of the path between the extruder and hot end. — Preceding unsigned comment added by 69.5.141.129 (talk) 2018-05-18T00:03:07 (UTC)

"Direct extrusion" also links to here

Latest comment: 3 years ago1 comment1 person in discussion

There is a link to "direct drive extruders" in this article that links to the Bowden extrudar article itself. — Preceding unsigned comment added by 158.42.231.67 (talk) 18:36, 26 February 2021 (UTC)Reply

Requested move 11 May 2021

Latest comment: 3 years ago3 comments3 people in discussion

The following is a closed discussion of a requested move. Please do not modify it. Subsequent comments should be made in a new section on the talk page. Editors desiring to contest the closing decision should consider a move review after discussing it on the closer's talk page. No further edits should be made to this discussion.

The result of the move request was: moved. (closed by non-admin page mover) ~ Aseleste (t, e | c, l) 00:35, 19 May 2021 (UTC)Reply

Bowden extruder → 3D printer extruder – The article currently discusses pros and cons of two different types of 3D printer extruders, namely the Bowden extruder and the direct drive extruder. It seems more appropriate to have an article name which corresponds with mentioning and comparing different types of extruders in general. Alternatively, the content may be merged into Fused filament fabrication. Sauer202 (talk) 20:08, 11 May 2021 (UTC)Reply

Support. Rreagan007 (talk) 18:43, 16 May 2021 (UTC)Reply

The discussion above is closed. Please do not modify it. Subsequent comments should be made on the appropriate discussion page. No further edits should be made to this discussion.

Add topic