The W79 Artillery-Fired Atomic Projectile (AFAP),[2] also known as XM753 (Atomic RA),[3][4] was an American nuclear artillery shell, capable of being fired from any NATO 8 in (203 mm) howitzer e.g. the M115 and M110 howitzer.[5] The weapon was produced in two models; the enhanced radiation (ERW) W79 Mod 0 and fission-only W79 Mod 1. Both were plutonium-based linear-implosion nuclear weapons.
- The Mod 0 was a variable yield device with three yields, ranging from 100 tons of TNT (420 GJ) up to 1.1 kt (4.6 TJ) and an enhanced-radiation mode which could be turned on or off
- The Mod 1 was fission-only with a fixed 0.8 kt (3.3 TJ) yield, corresponding with the maximum fission only yield of the Mod 0
W79 | |
---|---|
Type | Nuclear artillery |
Place of origin | United States |
Service history | |
In service | 1981 to 1992 |
Used by | United States Army |
Production history | |
Designer | Lawrence Livermore National Laboratory |
Designed | 1975 to 1981 |
Specifications | |
Mass | 200 pounds (91 kg) |
Length | 44 inches (1,100 mm) |
Diameter | 8 inches (203 mm) |
Maximum firing range | 24 kilometres (15 mi) or 30 kilometres (19 mi) with rocket assist[1] |
Blast yield | 0.1 to 1.1 kilotonnes of TNT (0.42 to 4.60 TJ) (Mod 0), 0.8 kilotonnes of TNT (3.3 TJ) (Mod 1) |
Both models were 8 in (203 mm) in diameter, 44 in (1,100 mm) long and weighed 200 lb (91 kg). The W79 was developed by Lawrence Livermore National Laboratory, starting in 1975. Production of the different mods took place from July 1981 through August 1986. A total of 550 warheads (325 Mod 0s, 225 Mod 1s) were produced.[6] All units were retired from active service by the end of 1992 with the last shell dismantled at the Pantex Plant in Texas in August 2002.[7]
History
editThe weapon received Phase 3 authorisation in January 1975 and cleared a critical budget review before the Joint Committee on Atomic Energy in April 1975.[8]
First production unit was in July 1981. Quantity production on the standard (non-ERW) W79-1 version of the weapon began in September 1981 and continued until the summer of 1984. Production of the ERW W79-0 version began in 1984 and continued until August 1986.[9]
During development, some part of the weapon was deemed too impractical to manufacture and a significant design revision was undertaken. This design changed the physics behaviour of the weapon and a new nuclear test was required to certify the new design.[10]
In early 1988, a new 3-dimensional computer simulation suggested that the weapon was not one-point safe under certain conditions. Nuclear testing carried out in December 1988 and February 1989 confirmed these findings.[11]
Design
editThe weapon had a range of 24 kilometres (15 mi) or 30 kilometres (19 mi) with rocket assist.[1]
The weapon utilized the M735 proximity fuze. It contained a dual-channel fuze system, target sensor, electronic programmer and power supply.[12] Its design goals were to minimize overall weight, minimize structural volume, eliminate the use of potting materials for structural support, and to eliminate cable and wire harnesses.[13] The goal of not using potting materials was ultimately not met.[14]
The fuze was developed with an extensive test firing program and in service use would have experienced a 10,400 g0 (102,000 m/s2) setback acceleration and 11,400 revolutions per minute (190 Hz) spin.[15] Some test units experienced setbacks of 15,300 g0 (150,000 m/s2).[16]
During early development, the intermediate cost Nonviolent Explosive Destruct System (NEDS) was selected to secure the weapon against unauthorised use.[8] This system was tested at Tonopah Test Range.[17]
Gallery
editSee also
editReferences
edit- ^ a b Sandia Weapon Review: Nuclear Weapon Characteristics Handbook (PDF) (Report). Sandia National Labs. September 1990. p. 75. SAND90-1238. Archived (PDF) from the original on 2022-01-12.
- ^ "W79 Artillery-Fired Atomic Projectile (AFAP)". Archived from the original on 2021-02-01. Retrieved 2021-01-28.
- ^ Henry E Hudgins (January 1977). Aerodynamics, Dimensions, Inertial Properties and Performance of Artillery Projectiles (PDF) (Report). Picatinny Arsenal. p. 4. Archived (PDF) from the original on 2021-12-19. Retrieved 2021-12-24.
- ^ Thomas B Cochran; William M Arkin; Milton M Hoenig (1984). Nuclear Weapons Databook, Volume I: US Nuclear Forces and Capabilities (PDF) (Report). Natural Resources Defense Council. p. 77. Archived (PDF) from the original on 2021-09-01. Retrieved 2021-12-24.
- ^ LLNL achievements in the 1970s
- ^ Hansen, Chuck (2007). The Swords of Armageddon, version 2. Chukelea Publications. pp. VI-521, VI-522.
- ^ Workers Dismantle Final U.S. Nuclear Artillery Shell
- ^ a b Department 1210 (October 1975). Military Liaison Department (1210) Activities-- FY 1975 (Report). Sandia National Lab. (SNL-NM), Albuquerque, NM (United States). p. 19. Retrieved 2022-08-08.
{{cite report}}
: CS1 maint: numeric names: authors list (link) - ^ Chuck Hansen (2007). Swords of Armageddon. Vol. VI. p. 522. ISBN 978-0-9791915-6-5.
- ^ Miller, G. H.; Brown, P. S.; Alonso, C. T. (1987-10-01). Report to Congress on stockpile reliability, weapon remanufacture, and the role of nuclear testing (Report). Lawrence Livermore National Lab., CA (USA). OSTI 6032983. Retrieved 2021-07-21.
- ^ Swords of Armageddon - Volume VI, p. 524.
- ^ Miller, John M.; Boring, Steven A. (1979-05-01). Structural Firing Tests of the M735 Proximity Fuze (Report). HARRY DIAMOND LABS ADELPHI MD. p. 6. Archived from the original on 2021-12-24. Retrieved 2021-12-24.
- ^ Structural Firing Tests of the M735 Proximity Fuze, p. 8.
- ^ Structural Firing Tests of the M735 Proximity Fuze, p. 37.
- ^ Structural Firing Tests of the M735 Proximity Fuze, p. 5.
- ^ Structural Firing Tests of the M735 Proximity Fuze, p. 25.
- ^ Environmental Assessment - Tonopah Test Range, Nevada (PDF) (Report). Energy Research and Development Administration (now Department of Energy). December 1975. p. 20. Retrieved 2023-12-23.